Pride Mobility Products LC-105 Manuel Du Propriétaire page 11

I V . A S S E M B L Y / D I S A S S E M B L Y
NOTE: See figure 4.2 for additional instructions regarding LC770 models.
4. Connect the hand control harness to the lift chair and heat/massage harnesses (if equipped) to the
lift chair (Fig 4.3).
WARNING! Do not connect the push-button or heat/massage hand control directly to the
motor. Connect the hand control directly to the junction box to prevent equipment damage.
5. Attach the chair-back to the hook and loop flaps on the bottom of the chair base.
Figure 4.2 LL770 Additional Assembly
For LL770 Lift Chairs, after attaching the
back per the KD instructions, fully recline
the lift chair and place the base flap over
the gap between the seat and back.
Using the reusable fasteners, secure the
base flap to the chair and then secure
the bottom-most pillow to the base flap.
Place the bolster pillow over the covered
gap, slightly wedging it between the back
and seat, and return the LL770 Lift Chair
to the seated position.
WARNING! Be aware that the average temperature of the heating pad ranges between 106°F
- 118°F (41°C - 48°C) and can be affected by the ambient temperature of the room and
clothing worn by the user. Your provider recommends that the heat units not be used for
more than 20 minutes at a time as prolonged exposure may have an adverse affect on
sensitive skin. However, you should consult the physician about how often you should use
the heat and massage options on your lift chair.
Lift Chair Series
HEAT CONNECTION
TO JUNCTION BOX
MASSAGE
UNIT
JUNCTION
BOX
*STANDARD HEAT/MASSAGE CONFIGURATION
Figure 4.3 Harness Connections
For units equipped with the heat and
massage option, connect the heat and
massage harnesses to the chair.
The heat pad(s) and massage units have
been factory installed on your lift chair. You
should only need to connect the harnesses
to the chair. If you find any further assem-
bly is required with this system, contact
your authorized provider immediately.
MASSAGE
UNIT
11