Ryobi P3150 Manuel D'utilisation page 7

INSTALLING ATTACHMENTS
See Figures 2 - 3, page 9.
Attachments are included with the heat gun to expand its
capabilities. Attachments are installed simply by placing
them on the end of the heat gun's nozzle.
NOTE: Install or remove attachments only when both the
heat gun nozzle and the attachment nozzle are cool.
Deflector nozzle: The deflector nozzle is useful for applying
heat to shrinkable tubing and thawing pipes.
Concentrator nozzle: The concentrator nozzle intensifies
the application of heat in a specific area. Uses for this nozzle
include bending acrylic plastic sheets and directing heat
into corners.
LOCK-OFF BUTTON
See Figure 4, page 9.
The lock-off button reduces the possibility of accidental
starting. The lock-off button is located on the handle above
the switch trigger. The lock-off button must be depressed
before you pull the switch trigger. The lock resets each time
the trigger is released.
NOTE: You can depress the lock-off button from either the
left or right side.
TURNING THE HEAT GUN ON/OFF
See Figure 4, page 9.
The heat gun has a lock-off button, located on the handle
above the switch trigger, reduces the possibility of accidental
starting.
 To turn the heat gun on: Depress the lock-off button
and press the switch trigger.
 To turn the heat gun off: Release the switch trigger.
LED LIGHT
See Figure 5, page 9.
The LED light, located on the front of the tool base, illuminates
when the switch trigger is depressed.
If the tool is not in use, the time-out feature will cause the
light to start fading and then shut off.
The LED light illuminates only when there is a charged battery
pack in the tool.
OPERATION
OPERATING THE HEAT GUN
See Figure 5 - 6, page 9.
WARNING:
Do not direct hot tip or nozzle toward clothing, hands,
or other body parts. Intense heat from tip or nozzle can
cause serious burns or cause clothing to ignite.
 Install the battery pack.
 Turn the heat gun on.
 Hold heat gun with one hand.
WARNING:
Do not place second hand on top of tool or near nozzle
at any time. Holding the tool on or near the nozzle can
cause serious personal injury.
 Move the heat gun until the nozzle is close to the area
being heated.
NOTE: Experiment with scrap materials to determine the
proper amount of heat, distance and time for your project.
WARNING:
During heating, move the tool back-and-forth. Avoid
lingering or pausing in one spot as this could overheat
or potentially ignite the material being heated.
 Allow the heat gun and the heated surface to cool
thoroughly, then remove the battery pack.
7 – English