Falltech Arc Flash Mini Pro Class 1 SRL-P Manuel De L'utilisateur page 8

4.7 Personal Fall Arrest System Anchorage Strength:
An anchorage selected for PFAS application must have the strength to sustain a static load applied in
the direction permitted by the PFAS of at least:
a. Two times the maximum arrest force permitted when certification exists, or
b. 5,000 lbs. (22.2 kN) in the absence of certification.
Select an anchorage location carefully. Consider structural strength, obstructions in the fall path, and
swing fall hazards. In certain situations, the Qualified Person can determine that a given structure is
able to withstand the applied MAF of the PFAS with a safety factor of at least two, as required by OSHA.
5.0 Installation and Use
Do not alter or intentionally misuse this equipment. Consult FallTech when using this
equipment in combination with components or subsystems other than those described in this
manual. All components or subsystems used with the SRD discussed in this manual must be in
Do not use rebar hooks, large carabiners or large snap hooks to connect to the FBH dorsal
D-rings or to any small diameter non-compatible anchor point as this may cause a roll-out
5.1 Installation to Full Body Harness
Installation for both Single-leg and Twin-leg configurations of the Arc Flash Mini Pro SRL-P follow the
same steps listed below:
Step 1: On the FBH, lift the dorsal D-ring to the up-pointing position, then loosen the intersection of
the two web straps that pass through the D-ring slot to create slacked loops of about 2" as shown in
Figure 3A. Note that some harnesses may have a built-in tunnel.
Step 2: Depress both release buttons and slide the locking bar into the open position as shown in
Figure 3B.
Step 3: Attach the connector to the slacked loops by inserting the locking bar through the slacked
loops as shown in Figure 3C.
Step 4: Make sure the locking bar is in the fully inserted and in the locked position, see Figure 3D.
A
8
compliance with ANSI Z359 and/or OSHA.
condition and/or unintentional disengagement.
Avoid sharp and/or abrasive surfaces and edges.
Figure 3 - Arc Flash Mini Pro SRL-P Installation
WARNING
B
Arc-flAsh
mini
SRl-p
Push
Push
Pull
Pull
Push
Arc-flAsh
mini
SRl-p
Push