DCS RGSC-305SS Guide D'utilisation Et D'entretien page 13

COOKTOP USE
FLAME HEIGHT
The correct height of the flame mainly depends on
the size of the bottom of the cooking utensil, the
material of the cooking utensil,the amount and type
of food and the amount of liquid in the utensil.
FoHHowing are some basic ruHes for seHecting flame
height.
Proper Flame Height
[] For safety reasons the flame must never
extend beyond the bottom of the cooking \_
utensil Never aHHowflames to cur[ up the side
of the pan.
[] Utensils which conduct heat showily (such as
gHass-ceramic) shouHd be used with medium
to How flames, ff you are cooking with a [arge amount of [iquid, a sHightHy[arger flame can be
used.
BURNERS
Sealed Top Burners (w/Grates removed)
The Sealed Top Burners must be kept clean. Cleaning of the sealed top burners should include the
igniter.
The cooktop burners have an infinite number of heat
settings and there are no fixed positions on the
control knobs between HI and LO. To turn the
cooktop burner on, push in on the control knob and
turn it counterclockwise to the "LITE" position. An
audible clicking sound will be heard. When the gas
has been ignited by the electronic spark igniter, turn
the knob to the desired setting. (This step turns off
the igniter and the clicking sound should stop.)
OFF
L[TE
/
NOTE: The igniter will continue to cfick as long as e control knob is in the "MTE" position.
CAUTION:
When turning on any cooktop burne_ be sure to stop at the "MTE" position
before turning the burner to e fleme setting for cooking. If the burner is not lit
end it is turned beyond the "LITE" position, to HI, MEDIUM, or LO, there will be a
burst of flame when the burner does fight. This could cause burns or damage
to the surrounding countertop.
BURNER GRATES
The burner grates are heavy cast iron.They were designed in sections to make
them easier to remove and clean.
12