Human Touch PC 095 Manuel D'utilisation Et D'entretien page 4

get ready
UNPACK THE BOXES
Head frame
Chair frame
Head sock Arm core 3/16-inch
Allen key
ATTACH THE BODY PAD
1. Slide the body pad onto the chair frame
Slide the body pad onto the lower part of the chair frame,
making sure that the frame slides into the fabric pocket located
on the bottom side of the pad.
2. Secure the body pad
Smooth the body pad into place, from the footrest toward the
backrest. The pad is automatically secured using the hook and
loop fasteners.
humantouch.com
Body pad Arm cap (2) Phillips-head
screwdriver
Head pad Ergo lumbar pillow Head pillow
6
Your Human Touch
simple assembly. Just attach the pads, arm core/
caps, and head pillow, and you're done!
ATTACH THE HEADREST FRAME
1. Raise the chair to an upright position
For your convenience, and to better position the chair for the remaining assembly,
plug in the chair, then use the electric recline lever to adjust the chair to an upright position.
2. Remove the headrest frame screws
Using the Phillips-head screwdriver (provided), remove the two
screws from the headrest frame. Retain them for use in step 4.
3. Insert the headrest frame into the backrest frame
With the arc of the headrest frame pointing backward, slide the two ends of
the headrest frame into the holes in the top of the backrest frame.
If the headrest frame is installed backward, the screw holes on the headrest
frame will not line up with the screw holes on the backrest frame.
4. Replace the headrest frame screws
Using a Phillips-head screwdriver, replace the two headrest frame
screws, securing the headrest frame to the backrest frame.
7 7
Perfect Chair requires some
® ®