Publicité
Les langues disponibles
Les langues disponibles
2. The Indicator light should light up once. Note the 5 second delay
between 2 signals. This is normal and intentional to save battery power.
3. If needed, adjust the detector angle to get the desired detection range.
When the detector indicator flashes
•
LED flashes once: A signal is detected and the detector sends a
signal to the Alarm unit.
•
LED continuously on: Low-voltage indication, please change the
battery as soon as possible.
Connecting the PIR Sensors to an Alarm Siren
This PIR sensor is compatible with the Tiiwee Home Alarm System.
Connect it wirelessly with one of the 433 MHz Alarm Units.
IMPORTANT: The instructions for pairing the PIR sensor with the Tiiwee
Home Alarm System are included with the Alarm units or can be
consulted on our website www.tiiwee.com or one of our Youtube
channels.
Advanced features
The Tiiwee PIR sensor is equipped with some additional features to allow
you to adjust the device to your specific needs. In order to access these
functions, remove the screw at the top of the sensor. Then separate the 2
parts (front and back part) by using an appropriate device (screw driver
i.e.). Now you can see the circuit board with the 2 switches.
Copyright © 2019 Tiiwee. All rights reserved. This manual or any portion thereof may not be reproduced or used in any manner whatsoever.
Publicité
