Braun Silk-epil Xpressive 7781 WD Mode D'emploi page 16

• When shaving or trimming in sensitive
areas, make sure that you always keep
your skin stretched to avoid injuries.
Contour trimming
For trimming precise line and contours, lock
the long hair trimmer by sliding the trim/
shave selector (e) to the position «trim» (C1).
Pre-cutting hair for epilation
If you choose to pre-cut your hair to the ideal
length for epilation, place the OptiTrim comb
(a) onto the shaver head. Slide the trim/shave
selector to the «trim» position.
Hold the appliance with the OptiTrim comb
lying flat on the skin. Guide it with the comb
tips against the hair growth as shown in
illustration C2.
N.B. As hair does not always grow in the
same direction, also guide the appliance
slightly diagonally or in different directions in
order to achieve best results.
Cleaning the shaver head
After each use, unplug the appliance.
Brush cleaning
• Press the release buttons (d) to remove the
shaver head (D1). Tap the bottom of the
shaver head gently on a flat surface (not on
the foil).
• Brush out the cutter block and the inside
of the shaver head. However, do not clean
the shaver foil with the brush as this may
damage the foil.
Cleaning with water
Press the release buttons (d) to remove the
shaver head. Rinse the shaver head and the
cutter block separately under running water
(D2). Leave the cutter block and the foil frame
to dry separately before reattaching them.
16
Keeping your shaver head attachment in
top shape
• The shaving parts need to be lubricated
regularly every 3 months (E). If you clean
the shaver head under running water,
please lubricate it after every cleaning.
• Apply some light machine oil or vaseline to
the shaver foil and the metal parts of the
long hair trimmer. Then remove the shaver
head and also apply a tiny amount of
vaseline as shown in picture section (E).
• The shaver foil and the cutter block are
precision parts that wear out with time. To
maintain optimum shaving performance,
replace your foil and cutter block when you
notice a reduced shaving performance.
• Do not shave with a damaged foil or cord.
How to replace the shaving parts
Shaver foil: Press the release buttons to
remove the shaver head. To remove the
shaver foil, press the foil frame (F). To
mount a new one, insert it from inside the
shaver head.
Cutter block: To remove the cutter block,
press and turn it 90° (G1), then take it off.
To put on a new cutter block, press it onto
the cutter block holder and turn 90° (G2).
Replacements parts (shaver foil, cutter block)
can be obtained from your retailer or Braun
Customer Service Centres.
For electric specifications, please see printing
on the special cord set. The special cord set
automatically adapts to any worldwide AC
voltage.