i-tec U3TRAVELDOCK Mode D'emploi page 7

Quick Start / USB 3.0 Travel Docking Station EN
chipset which needs to have the current drivers available.
Problems that you can encounter during the installation or use of our USB
3.0 equipment are very often caused by the installed outdated drivers for the
USB 3.0 controller or chipset of your notebook / tablet / PC. Other problems
can be caused by outdated firmware of the USB 3.0 port controller. Most
frequently it is one of the following manufacturers: Intel, Renesas (former
NEC), Via (VLI), AS Media, Fresco Logic, Etron.
You can find the most recent drivers for the i-tec products on our website
www.i-tec.cz/en in the „Download" tab for the individual products.
Note:
Before the first connection of the docking station to a notebook / tablet / PC
it is necessary first to install the LAN and VGA / HDMI port from
www.i-tec.cz/en and only then to connect the equipment to the docking
station.
INSTALLATION OF DRIVERS IN WINDOWS 7 / 8 / 8.1 / 10 (32/64 BIT
VERSION)
Before the first use do not connect the docking station to the notebook
/ tablet / PC, until you install the corresponding drivers for the LAN and
VGA / HDMI port from www.i-tec.cz/en. The equipment drivers need to be
installed only before the first use.
In Windows 7 / 8 / 8.1 / 10 install the VGA / HDMI port as the „Administrator".
The monitor may be flashing during the installation of the drivers – this is a
standard process. After the completion of the installation we recommend
restarting the notebook / tablet / PC.
HARDWARE INSTALLATION (CONNECTING THE DOCKING STATION TO
A NOTEBOOK / TABLET / PC)
1) Turn ON the notebook / tablet / PC.
2 ) Connect the USB 3.0 cable on the back panel of the docking station to a
free USB 3.0 / 2.0 port of your notebook / tablet / PC.
3) Subsequently, the automatic installation of the ports in the individual
systems will start.
4) After the completion of the installation restart the notebook / tablet / PC.
INSTALLATION OF DRIVERS IN MAC OS X
Before the first use do not connect the docking station to the MacBook /
PC, until you install the corresponding drivers for the LAN and VGA / HDMI
port from www.i-tec.cz/en. The equipment drivers need to be installed only
before the first use.
7