Publicité
Les langues disponibles
Les langues disponibles
6
Troubleshooting
A
If you cannot eliminate the problem although you follow the instructions in this section, consult your
dealer or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.
Drying process takes too much time.
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•
•
Filter drawer is clogged.
•
Ventilation grids on the front side of the machine are blocked.
that block ventilation in front of the ventilation grids.
Ventilation is not sufficient since the room where the machine is installed is very small. >>> Open the
•
door and window of the room to avoid the room temperature increase too much.
•
Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
Excessive laundry is loaded. >>> Do not load the dryer in excess.
•
•
Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your washing
machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
•
It is likely that the selected programme did not suit the laundry type.>>>Checking the care labels on
clothes, select appropriate programme for the laundry type or use timer programmes in
addition.
•
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
•
Excessive laundry is loaded. >>> Do not load the dryer in excess.
•
•
Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your washing
machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is set.
It is not plugged in. >>> Make sure that the machine is plugged in.
•
•
The loading door is ajar. >>> Make sure that the loading door is closed securely.
Programme is not selected or the Start / Pause / Cancel button is not pressed. >>> Make sure that the
•
programme is selected and the machine is not in Pause mode.
•
Childproof Lock is activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
Loading door is ajar. >>> Make sure that the loading door is closed securely.
•
•
There was a power failure. >>> Press Start / Pause / Cancel button to start the programme.
•
Condensate tank is full. >>> Drain the condensate tank.
Laundry has shrunk, become felted or deteriorated.
A programme suitable for the laundry type is not used. >>> Check the garment tag and select a
•
programme suitable for the fabric type.
Drum lighting does not turn on. (On models with lamp)
•
Dryer is not switched on with the On / Off button. >>> Make sure that the dryer is switched on.
Lamp is defective. >>> Call Authorized Service Agent to have the lamp replaced.
•
108 / 112 EN
Clean the sponge and the filter cloth in the filter drawer.
>>>
Remove the objects (if any)
>>>
Dryer / User Manual
Publicité
