Setting The Time And Day Of The Week - DeLonghi PALACE 1800/1 Mode D'emploi Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

HOW TO USE THE CHRONOTHERMOSTAT
The thermostat has different operating modes which can be cyclically
selected by the user using the MODE button.
According to Commission Regulation (EU 2015/1188 of 18 April 2015,
seasonal energy efficiency of local electric powered radiators fixed of
which the rated thermal power is greater than 250W, it is not less than 38%.
η
= η
-10% + F (1) + F (2) + F (3) - F (4) - F (5)
s
s,on
wth
F (2) = 7,0% electronic control of ambience temperature and of the weekly timer;
F (3) = 1,0% electronic control of ambience temperature with open window detection;
it results:
η s = 40% - 10% + 7% + 1% = 38%
1. STAND-BY
The radiator does not work in STAND-BY mode. The display shows the real time in the
clock section of the screen. If the time and day are flashing, they are not valid for
operation and must be set by the user. To switch from stand-by mode to another
operating mode, press the STAND-BY button (the FIRST one at the top) for 2 seconds.
When you exit stand-by mode, the last operating mode will be restored and displayed on the screen.
[Fig. 10]

2. SETTING THE TIME AND DAY OF THE WEEK

The time and day of the week must be set only when it is switched on for the first time or when
the power supply is disconnected and reconnected (the time flashes on the screen).
The thermostat clock can only be changed in STAND-BY mode (to enter this mode, press the
STAND-BY button for 2 seconds). If you press the MODE button for two seconds, the screen
will display the word "SET" for an instant and propose modification of the TIME and DAY OF
THE WEEK.
The time can be adjusted by pressing the PLUS or MINUS key (press and hold to move quickly).
Press the MODE key to confirm the clock setting and then set the day
of the week.
The screen momentarily displays the word "DAY" and proposes the day of the week, where D1
is Monday. Use the PLUS and MINUS keys to set the current day of the week (for example,
if today is Thursday, press the PLUS key 4 times to D4).
Then press the MODE key to confirm and exit clock programming.
Once the time has been adjusted, it is displayed steady (not intermittent).
To switch from STAND-BY mode to any other operating mode, press the STAND-BY key for
2 seconds.
[Fig. 11]
21
[Fig. 9]

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Palace 1800/2Palace 1800/3Palace 1800/4

Table des Matières