LUCCI Air BALI Instructions D'installation page 15

BALI Installation Instructions
REMOTE CONTROL (Fig. 13)
The LED light has a 3-step dimmable function which is controlled by an ON/OFF switch.
When the LED light is ON and at 100% brightness, press the light button "ON and then OFF within 5
seconds", to dim the LED light. Repeat pressing ON and then OFF within 5 seconds to dim further in the
following sequence: 100% brightness → 50% brightness → 15% brightness → 100% brightness.
The remote has memory function. If the fan or light is turned off by the isolating switch, it will memorise and
recover the last status when turned on next.
REPAIRING THE REMOTE & RECEIVER PAIRING – WHEN 1 CEILING FAN IS INSTALLED

If the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired.

Below are the operating symptoms and the steps to repair the pairing of the remote and receiver.
Symptoms:

Loss of control - Fan is only running at high speed after installation

Loss of control - No reverse function after installation

Loss of control - Remote cannot communicate with the receiver
Repairing Steps:

Switch OFF the main power to the ceiling fan for 30 seconds.

Switch ON the main power of the ceiling fan. Follow the same process as described in the 'Paring remote
& receiver' section to repair the pairing.

Turn on and select the different speed of the ceiling fan to check the operation of the fan.
14 | P a g e
(1) Reverse control
(2) Natural wind (The fan speed automatic cycle
between 1 to 6 speed)
(3) Speed control
(4) Light On/Off
(5) Fan On/Off
(6) 1.5V AAA battery x 2 pcs (Not Included)
Fig. 13