Publicité
Les langues disponibles
Les langues disponibles
Risk of bodily injury, electric shock, or equipment damage.
•
Operation of this equipment requires detailed installation and operation instructions provided in this manual. Read entire manual
before starting installation and operation. End User should receive and retain manual for future use.
•
This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in experi-
ence and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play with the unit or in
the immediate vicinity.
•
Equipment can start automatically. Always unplug the pump power cord and disconnect the electrical power before servicing the
pump or switch.
•
An inoperative or malfunctioning pump could lead to flooding, resulting in personal injury or property damage. Use with
approved liquid level control with correct rating that matches marked motor input in full load amperes or service factor amperes.
•
In applications where property damage and/or personal injury might result from an inoperative or leaking pump due to power
outages, discharge line blockage, or any other reason, an automatic back-up system and/or an alarm should be installed.
•
Do not run the pump dry. If run dry, the surface temperature of the pump will rise to a high temperature that could cause skin
burns if touched and will cause serious damage to your pump.
•
Do not oil the motor. The pump's motor housing is sealed, with a high-grade dielectric oil for heat transfer and lifetime lubrica-
tion. Use of other oils could cause serious electric shock and/or permanent damage to the pump.
•
Keep safety labels clean and in good condition.
•
Do not use motor in swimming areas or marine applications.
•
Manual, continuous pump operation should be used only for emergencies, or when a large volume of water is to be pumped. The
pump must be continuously monitored during operation and disconnected from power before the pump runs dry.
•
The pump has been evaluated for use with water only. Pump should only be used with liquids compatible with pump component
materials. If the pump is used with liquids incompatible with the pump components, the liquid can cause failure to the electrical
insulation system resulting in electrical shock.
Risk of damage to pump or other equipment.
•
Do not use this pump for pumping sea water, beverages, acids, chemical solutions, or any other liquid that promotes corrosion as
this can result in damage to the pump.
•
Do not run pump dry. For optimal cooling and to prolong the motor life, the liquid level being pumped should normally be above
the top of the pump housing.
•
This pump is not suitable for pond applications.
INSTALLATION
Typical Installation
1
Gas Tight Basin
2
Discharge
3
Union
4
Check Valve
5
Gate Valve
6
Intake
7
Air Bleed Hole
8
Vent
See
"Electrical
9
Connections" on
page
5.
10 Caulking Hub
5
4
3
2
6
10
7
INSTALLATION
Typical Installation
9
8
1
3
Publicité
