Key Automation COMFORT ST Serie Instructions Et Avertissements Pour L'installation Et L'usage page 4

EN
2 - PRODUCT OVERVIEW
2.1 - Description of the product
The COMFORT ST gear motors are destined to be installed in sys-
tems for the automation of gates with hinged doors.
The COMFORT ST gear motors have been designed and construct-
ed to be fitted onto hinged doors within the weight limits indicated in
2.2 - Technical characteristics
TECHNICAL DATA
TECHNICAL SPECIFICATIONS
Speed
Thrust Force
Working cycle
Opening time at 90°
Control unit
Power supply
Absorption
Engine power
Degree of protection
Dimensions (L - P - H)
Weight
Operating temperature
Leaves maximum weight
3 - PRELIMINARY CHECKS
Before installing this product, verify and check the following steps:
- Check that the gate or door are suitable for automation
- The weight and size of the gate or door must be within the maxi-
mum permissible operating limits specified in Fig. 2
- Check the presence and strength of the security mechanical stops
of the gate or door
- Check that the mounting area of the product is not subject to flood-
ing
- Conditions of high acidity or salinity or proximity to heat sources
could cause malfunction of the product
- Extreme weather conditions (for example the presence of snow,
ice, high temperature range, high temperatures) may increase the
friction and therefore the force required for the handling and initial
4
MODELS
the technical specifications table.
The use of gear motors for applications which differ from those indi-
cated above is prohibited.
ST3024
cm/s 2,5
N 1400
% 80
sec adjustable
CBX20324L
Vdc 24
A 3,5
W 85
IP 54
mm 796 - 115 - 177
Kg 3,2
°C -20°+55
Kg 400
starting point may be higher than under normal conditions.
- Check that the manual operation of gate or door is smooth and
friction-free and there is no risk of derailment of the same
- Check that the gate or door are in equilibrium and stationary if left
in any position
- Check that the power line to supply the product is equipped with
proper grounding safety and protected by a magnetothermal and
differential security device
- Provide the power system with a disconnecting device with a gap
of contacts enabling full disconnection under the conditions dictated
by the overvoltage category III.
- Ensure that all materials used for the installation comply with cur-
rent regulations