Garland MULE 561 QG-V20 Manuel D'instructions page 42

English
6.4.2.3. STOPPING THE ENGINE
- Place the throttle lever in positions the minimum
speed and allow the engine to remain idle
seconds.
- Place the accelerator in the "STOP" position.
6.4.3. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible individual
parts or and the temperature of the machine. If you
detect any anomaly in the machine immediately stop
and check it carefully. In case of any malfunction or
problem take the machine to a service technician to be
repaired. In any case continue to use the machine if the
operation does not seem appropriate.
Do not use the machine if it is damaged or
improperly adjusted.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Do not approach the milling cutters of the rotary tiller
when the motor is running.
Do not start the machine in a room or
enclosure.The exhaust gases and fuel and
oil vapors contain carbon monoxide and
harmful chemicals. In case of a concentration of gases
produced by poor ventilation, remove all that impedes
the flow of clean air to improve ventilation from the
work area and not return to work in the area unless
you have properly ventilated area and have clear that
ventilation is sufficient so that does not happen this
concentration again.
Work only in daylight or good artificial light. Do not use
this machine at night, with fog or with a low visibility
which do not allow you to clearly see the working area.
Limit continued use of this machine to a 10 minute
time limit and between 10 and 20 minutes to rest
between each session.
If you slip or fall, stop acceleration and move the
switch to the "STOP" position.
Do not use this machine if you are tired, ill, have taken
drugs, narcotic drugs or alcohol. The lack of rest and
fatigue can cause accidents or damage.
Always readjust the machine on a flat and stable
surface.
Do not use the machine on steep slopes where you
cannot guarantee their safety. If you are working on
slopes slow down your work pace and ensure you
have good stability.
Be alert when you back-up or pull the machine
towards you.
Do not solely rely on the security features of this
machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine. If
you detect any anomaly immediately stop the machine
and check it carefully. In case of mechanical failure
take the machine to the technical service for repair.
You should not continue working if you notice that the
operation is not correct.
Remember to always use the machine with clean
hands and without any fuel or oil remains.
42/160