Elica PWLCL630SS Guide D'utilisation, D'entretien Et D'installation page 11

3 Slide the left mounting plate flange under the motor mounting
bracket.
B
A
4 Run the power supply wires and connector from the range
hood through the hole in the right end of the motor mounting
plate.
A. Motor mounting plate hole
B. Power supply wires and connector
5 Push the right end of the motor mounting plate up and snap it
into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
A. Motor mounting plate
B. Spring clip
A. Motor mounting bracket
B. Mounting plate left flange
A
B
A
B
6 Align mounting holes and install 6 x 16 mm screws and 6.4 mm
lock washers
B
A. Screw with lock washer
B. Mounting hole
7 Attach power supply connector from the range hood to the
connector on the blower motor assembly wiring box.
A
B
A. 4- 4x8 mm mounting screws
B. Security screws
A
11