Rowenta DX1550 Mode D'emploi page 7

PROBLEMS
Your iron produ-
ces little to no
steam.
The soleplate is
scratched or da-
maged.
The iron steams
once the water
tank has been
filled.
The spray does
not spray water.
If you cannot determine the cause of a fault, you can contact the ROWENTA official, approved
after-sales service. You will find the addresses in the attached list of after-sales services.
You can also find advice and tips on our homepage at: www.rowenta.com
POSSIBLE CAUSES
The water tank is empty.
The anti-calc valve is dirty.
Your iron is clogged up with
limescale.
Your iron has been used for
too long in the dry ironing
function.
You have placed your iron
on a metallic iron rest or
ironed over metal zips or
fastners.
The steam control dial is
not set to .
The water tank is too full.
The water tank is not full
enough.
6
SOLUTIONS
Fill it up.
Clean the anti-calc valve.
Refer to "Cleaning the
anti-calc valve" section.
Clean the anti-calc valve
and steam chamber.
Refer to "Cleaning the
anti-calc valve" and
"Self-cleaning function"
sections.
Clean the steam
chamber. Refer to
"Self-cleaning function"
section.
Always place your iron
on its heel rest when not
in use.
Do not iron over metal
zips or fastners.
Ensure that the steam
control dial is set to
Do not exceed the max
level for filling.
Add water to the water
tank until max level.
EN
.