Orion XTR Serie Manuel Du Propriétaire page 12

_
+
tri-Mode six Channel Configuration
• Lowest recommended impedance is 2
mono .
• Front and rear outputs must be set for full range operation .
+
_
• Passive crossovers must be used on all components and frequen-
cies must not overlap .
WARNING! Failure to observe these requirements may result in dam-
age to the amplifier
_
+
1CH
2CH
+
_
Figure 12
Figura 12
Abbildung 12
NOTE: to get full output in this configuration, band limiting filters as
shown in this diagram may need to be used to prevent the impedance
from dropping too low and engaging protection circuits .
© 2008 Directed Electronics. All rights reserved.
All manuals and user guides at all-guides.com
_
+
1CH 3CH
Ω stereo and 4Ω bridged
2CH 4CH
+
_
+
_
_
+
1CH
2CH
+
_
_
3CH
4CH
+
_
+
3CH
4CH
+
_
11