Falcon CLAS90EICR/B-EU Instructions D'installation Et D'entretien page 31

Fig.7-14

ArtNo.000-0012 - Securing the plinth

Fig.7-15

ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)

Fig.7-16

ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)

��

Fig.7-17

��

Check the appliance is electrically safe when you have ﬁnished.

��

INSTALLATION

Fitting the Plinth

Loosen the three screws along the front bottom edge of the

cooker. Hook the central keyhole over the central screw. Twist

and ﬁt each end keyhole over their respective screws. Tighten

the ﬁxing screws (Fig.7-14).

Fitting the Plinth

Fit the inner plinth to the bottom front of the cooker using

the 5 screws provided (Fig.7-15).

Fit the outer plinth (2 screws, 1 each end) to the inner plinth.

The height of the outer plinth can be adjusted by sliding it up

or down via the slotted hole (Fig.7-16).

Fitting the Splashback

The splashback secures to the back of the hotplate using the

securing clips and screws provided. Slide the clips into the

openings on the rear of the hotplate, making sure to align the

holes in the clips to the holes in the hotplate (Fig.7-17).

Position the splashback on the rear of the hotplate and secure

with the screws supplied.

Customer Care

Installer: Please complete your details in this Guide, inform

the user how to operate the cooker and hand oven the

instructions.

Thank you.

(Kitchener and Toledo only)

(optional)