Beurer IH 60 Mode D'emploi page 24

Particle size diagram
Measurements were performed using a sodium fluoride
solution with a "Next Generation Impactor" (NGI).
The diagram may therefore not be applicable to suspensions
or highly viscous medications. You can obtain more detailed
information from the manufacturer of your medication.
12. Replacement parts and wearing
parts
Designation
Year pack (contains mouthpiece, nose-
piece, adult mask, children's mask,
atomiser, compressed air hose, filter)
Baby mask
Note
If the device is not used according to the instructions spec-
ified, perfect functionality cannot be guaranteed! We re-
serve the right to make technical changes to improve and
develop the product. This device and its accessories com-
ply with the European standards EN60601-1, EN60601-1-
2 (CISPR 11, IEC61000-3-2, IEC61000-3-3, IEC61000-4-2,
IEC61000-4-3, IEC61000-4-4, EC61000-4-5, IEC61000-
4-6, IEC61000-4-7, IEC61000-4-8, IEC61000-4-11) and
EN13544-1 and are subject to particular precautions
with regard to electromagnetic compatibility. This device
meets the requirements of European Directive 93/42/EEC
for medical devices, as well as those of the Medizinpro-
duktegesetz (German Medical Devices Act).
NOTES ON ELECTROMAGNETIC COMPATIBILITY
• The device is suitable for use in all environments listed
in these instructions for use, including domestic envi-
ronments.
• The use of the device may be limited in the presence
of electromagnetic disturbances. This could result in
issues such as error messages or the failure of the dis-
play/device.
• Avoid using this device directly next to other devices or
stacked on top of other devices, as this could lead to
faulty operation. If, however, it is necessary to use the
device in the manner stated, this device as well as the
other devices must be monitored to ensure they are
working properly.
• The use of accessories other than those specified or
provided by the manufacturer of this device can lead to
an increase in electromagnetic emissions or a decrease
in the device's electromagnetic immunity; this can result
in faulty operation.
13. Warranty/service
In case of a claim under the warranty please contact your
local dealer or the local representation which is mentioned
Material REF
in the list "service international".
PP/PVC 163.904
In case of returning the unit please add a copy of your
receipt and a short report of the defect.
The following warranty terms shall apply:
PVC 601.31
1. The warranty period for BEURER products is either 5
2. Repairs (complete unit or parts of the unit) do not ex-
3. The warranty shall not be valid for damages because of
4. Liability for direct or indirect consequential losses
24
years or- if longer- the country specific warranty period
from date of Purchase.
In case of a warranty claim, the date of purchase has
to be proven by means of the sales receipt or invoice.
tend the warranty period.
a. improper treatment, e.g. nonobservance of the user
instructions.
b. repairs or tampering by the customer or unauthor-
ised third parties.
c. transport from the manufacturer to the consumer or
during transport to the service centre.
d. The warranty shall not be valid for accessories which
are subject to normal wear and tear (cuff, batteries
etc.).
caused by the unit are excluded even if the damage to
the unit is accepted as a warranty claim.