Publicité
Les langues disponibles
Les langues disponibles
Safety and operating instructions
1. Screw the retainer on the cylinder by hand until
it is tight.
2. Push the retainer sleeve upwards and insert the
chisel shank in the cylinder.
3. Release the retainer sleeve and make sure the
sleeve returns to its end position.
Operation
WARNING
Involuntary start
Involuntary start of the machine may cause injury.
►
Keep your hands away from the start and stop
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
Start and stop
The CP0016, CP4130 and CP4131 models are
equipped with a throttle lever and a lock-off trigger.
The lock-off trigger is positioned inside the D-handle.
It locks the throttle lever (positioned on top of the
D-handle) and prevents the machine from starting
accidentally.
Start the machine by pulling the lock-off trigger
♦
to position (A) and squeezing the throttle lever
towards position (C).
Stop the machine by releasing the throttle lever
♦
and the lock-off trigger. The throttle lever will
automatically return to position (D) and the
lock-off trigger will return to position (B).
16
CP 0016, CP 4130, CP 4131
Operating
Starting a cut
Stand in a stable position with your feet well away
♦
from the inserted tool.
♦
Press the machine against the working surface
before you start.
♦
Start collaring at such a distance from the edge
that the machine is capable of breaking the
material without levering.
Never try to break off too large pieces. Adjust the
♦
breaking distance (A) so that the inserted tool
does not get stuck.
Breaking
Let the machine do the work; do not press too
♦
hard.
♦
Avoid working in extremely hard materials for
example granite and reinforcing iron (re-bar)
which would cause substantial vibrations.
Any form of idling, operating without insertion
♦
tool or operating with an uplifted machine must
be avoided.
♦
When the machine is lifted, the start and stop
device must not be activated.
♦
Check regularly that the machine is well
lubricated.
When taking a break
During all breaks you must place the machine in
♦
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
♦
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
9800 0616 90a | Original instructions
Publicité
