Publicité
Les langues disponibles
Les langues disponibles
CP 0016, CP 4130, CP 4131
Recommended insertion tools are listed in the
machine's spare parts list.
Narrow chisel
Moil point
Wide bladed chisel
WARNING
Vibration hazard
Using inserted tools that do not fulfil the criterias
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is
►
well-maintained, not worn out and of the proper
size.
►
Always use a sharp tool in order to work
efficiently.
Fitting and removing the insertion tool
Whenever fitting or removing the insertion tool the
following instructions must be observed:
To prevent an accidental start: switch off the
♦
power supply and disconnect the machine from
the power source. Bleed the machine by pressing
the start and stop device.
Before inserting a tool, lubricate the tool shank
♦
with grease.
Close the tool retainer and check the lock function
♦
by tugging the inserted tool sharply outwards.
9800 0616 90a | Original instructions
The narrow chisel is used for
demolition and cutting work in
concrete and other types of
hard materials.
The moil point is only used for
making holes in concrete and
other types of hard materials.
The wide bladed chisel is used
in soft materials, such as
asphalt and frozen ground.
Safety and operating instructions
CP 0016
1. Slide the retainer over the shank and collar onto
the chisel.
2. Open the buffer (A) and place it on the chisel
between the retainer and the collar.
3. Insert the chisel shank into the cylinder, and
screw the retainer onto the cylinder with hand
force until it is tight.
CP 4130
1. Insert the chisel shank into the cylinder.
2. Slide the retainer over the chisel and on to the
cylinder.
3. Insert the lock coil (A).
CP 4131
15
Publicité
