Operation - General - Bestron DHY1705 Mode D'emploi

operAtion - general

The ice-cream maker is intended
only for domestic use.
1. Motor housing
2. On/Off switch
3. Power cord with plug
4. Drive shaft
5. Cover with filling opening
6. Mixing paddle
7. Cooler compartment
8. Locking clip
operAtion - before use for the first time
1. Remove the packaging.
2. Clean the cooler compartment, the lid and the mixing paddle to remove any manufacturing residues.
See 'Cleaning and maintenance'.
operAtion - freezing the cooler compartment
The most important step in making ice cream is freezing the cooler compartment. This consists of a
double-insulated container that needs a certain amount of time to freeze properly. The time depends on the
temperature in your freezer.
1. Place the cooler container in the freezer. At a temperature of -18 °C it takes at least 12 hours until
the container has cooled properly. At a higher temperature this takes longer. Preferably, leave the
container in the freezer overnight. If you always leave the container in the freezer you can make ice
cream whenever you want!
2. Remove the cooler container from the freezer immediately before making the ice cream.
operAtion - making ice cream
1. Prepare the ingredients and mix them together according to the
instructions in the recipe (see 'Recipes').
2. With cooked ingredients, place the mixture in a pan of cold
water to let them cool down.
3. Place the mixture in the refrigerator to let them cool down
(further) before you place them in the cooler container (7).
4. Insert the mixing paddle (6) in the opening on the underside of
the motor housing (1+4).
5. Place the motor housing on the cover (5). Push the mixing
paddlethrough the hole in the cover. Move the motor housing
forwards until it clicks into place in the cover.
6. Take the cooler container out of the freezer.
7. Place the cover on the frozen cooler container so that the cams
on the cover align with the cutouts in the cooler container
8. Turn the locking clip (8) clockwise until it clicks into position.
9. Put the plug (3) in the wall socket.
10. Turn the On/Off switch (2) on (position '1').
11. Place the ingredients in the cooler container beaker through the
filling opening.
1
4
22
instruction manual
2
3
5
6
8
7
Figure 1
Figure 2