BorMann PRO BCP3160 Mode D'emploi page 5

EN
TECHNICAL SPECIFICATIONS
Technical data
Model BCP3160
Power 600 W
Disc Diameter 30/50/75mm
No Load Speed 2000-4500 rpm
Constant Speed & Soft Start, Ergonomically
Other features
operating design with rubber grip
Includes
DESCRIPTION
Intended Use
This manual polisher is designed for:
• industrial use in production and workshops, for all types of polishing work, for example: for polishing the varnished surface of cars, polishing furniture, metal
surfaces, etc. using polishing sponges, sheepskin or wool discs.
• use with polishing tools designed to operate at a speed of at least 2000 rpm.
Fig.1
1. Housing
2. Reducer
3. Fixing screw
4. Disc with Velcro
5. Switch button
6. Speed controller
OPERATING INSTRUCTIONS
WARNING
Before starting any maintenance work on the polisher, be sure to remove the plug from the socket.
Before operation
Unpack the polisher, check the delivery for completeness and check the machine for transport damage.
Fixing or changing the tool (Fig. 2,3)
• Remove the plug from the socket.
• The polishing pad (4) is screwed onto the spindle of the polishing machine.
• The accessory is fixed directly on the polishing pad with Velcro.
• Center the polishing tool (1), press it firmly against the Velcro pad (2).
Use only completely intact polishing tools. Incorrectly mounted working attachments cause jerks and vibrations.
• Insert the plug into the socket.
• Turn on the polisher and let it run for about 30 seconds. Make sure that the disk rotates without beating and vibration!
• Switch off the polisher.
Replacing the polishing pad (Fig.3)
• Remove the plug from the socket.
• Remove the polishing tool.
• Unscrew the fixing screw (2) with the key (1), remove the Velcro plate (3).
• Remove dirt from the inside of the gearbox.
• Put on a new plate with Velcro and insert the fixing holes.
• Insert the screw into the spindle hole and tighten it tightly.
• Perform a test run. Check disc for imbalance and vibration.
5
- 1 pc 30mm,1pc 50mm
- 1 pc 75mm backing plate
- 1 pc 30mm
- 1 pc 50mm
- 1 pc 75mm foam pad
- 1 pc 75mm
- 1 pc 100mm extension rod
- 1 set spare carbon brush
- Extension Rod Set & Flexible Hose Set
Fig.2
1. Polishing pad
2. Disc with Velcro
WWW.NIKOLAOUTOOLS.COM
* The manufacturer reserves the right to make minor changes to product design and technical
specifications without prior notice unless these changes significantly affect the performance and
safety of the products. The parts described / illustrated in the pages of the manual that you hold in
your hands may also concern other models of the manufacturer's product line with similar features
and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection
or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided
equipment may cause malfunctions or even serious injury or death. The manufacturer and the
importer shall not be liable for injuries and damages resulting from the use of non-conforming
equipment.
Fig.3
1. Hex key
2. Drive screw
3. Disc with Velcro