Makita DPJ180 Manuel D'instruction page 7

The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
When the fence is set at 90°, both the distance from the center of the
blade thickness to the fence and the distance from the center of the
blade thickness to the bottom of the blade cover are 10 mm (0.4").
Set plate
2
5:
3
4mm
4
10mm
10mm
6mm
► 1. Lock lever 2. Pointer 3. Angle scale 4. Set plate
5. Thickness of set plate 6. Center of blade thick-
ness 7. Blade cover
1
► 1. Set plate
Use the set plate as shown in the figures when cutting
slots in thin workpieces.
Switch action
1
► 1. Slide switch
1
7
6
CAUTION:
• Before installing the battery cartridge into the
tool, always check to see that the slide switch
actuates properly and returns to the "OFF"
position when the rear of the slide switch is
depressed.
• Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, slide the slide switch toward the "I
(ON)" position. For continuous operation, press the
front of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Removing or installing the blade
6
5
► 1. Lock nut 2. Plate joiner blade 3. Blade cover
4. Inner flange 5. Clamp screw 6. Shaft lock
7. Loosen 8. Tighten
CAUTION:
• When installing the plate joiner blade, mount the
inner flange with the side marked "22" facing
toward you.
To remove the blade, loosen the clamp screw and open the blade
cover. Push the shaft lock and loosen the lock nut using the lock
nut wrench. To install the blade, first mount the inner flange.
Then mount the blade and the lock nut. Securely tighten the
lock nut using the lock nut wrench. Close the blade cover
and tighten the clamp screw to secure the blade cover.
CAUTION:
• Use only Makita lock nut wrench provided to
remove or install the blade.
• Always check the depth of groove after replac-
ing the blade. Reajust it if necessary.
7 ENGLISH
1
8
7
2
3
4