Bosch GKS 18V-68 GC Notice Originale page 28

28 | English
Number of speed settings
ECO
2
3
4
5
6
A) ±25 %
You can use the button for speed preselection (36) to preselect the required speed, even during operation.
Status indications
GKS 18V-68 GC
Battery charge indicator Meaning/cause
(user interface) (34)
Green (2 to 5 bars) Battery charged
Yellow (1 bar) Battery almost empty
Red (1 bar) Battery empty
Temperature indicator (40) Meaning/cause
Yellow Critical temperature has been reached (mo-
tor, electronics, battery)
Red Power tool is overheated and will switch off
Power tool status Meaning/cause
indicator (39)
Green Status OK
Yellow Critical temperature has been reached or bat-
tery is almost empty
Red Power tool is overheated or battery is empty
Flashing red Restart protection is triggered
Connectivity functions
GKS 18V-68 GC
In conjunction with the Bluetooth® Low Energy Module
GCY 42, the following connectivity functions are available
for the power tool:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
– Setting the speed levels
Further information can be found under the Power tool
status display (39) on a mobile device if it is connected via
Bluetooth® wireless technology.
1 609 92A 8FS | (07.06.2023)
Basic speed setting at level
1 2 3
-1 -1
[min ] [min ] [min
A)
3630 – –
2500 5000 –
2500 3800 5000
2500 3300 4200
2500 3100 3800
2500 3000 3500
Read the corresponding operating instructions for informa-
tion about the Bluetooth® Low Energy Module GCY 42.
GKS 18V-68 C
In conjunction with the Bluetooth® Low Energy
Module GCY 42, the following connectivity functions are
available for the power tool:
– Registration and personalisation
– Status check, output of warning messages
– General information
– Management
Read the corresponding operating instructions for informa-
tion about the Bluetooth® Low Energy Module GCY 42.
4 5
-1 -1 -1
] [min ] [min ]
– –
– –
– –
5000 –
4400 5000
4000 4500
Solution
–
Replace or charge battery soon
Replace or charge battery
Solution
Run the power tool at no load and allow it to
cool down
Leave the power tool to cool down
Solution
–
Run the power tool at no load and allow it to
cool down, or replace or charge the battery
soon
Allow the power tool to cool down, or replace
or charge the battery
Turn the power tool off and on again; if neces-
sary, remove the battery and reinsert it.
6
-1
[min ]
–
–
–
–
–
5000
Bosch Power Tools