Publicité
Les langues disponibles
Les langues disponibles
Care and Maintenance
AIR FILTER
UNIT ENCLOSURE
LONG-TERM STORAGE
Upper fi lter
Lower fi lter
1. Be sure to unplug the unit before cleaning or servicing.
2. Do not use gasoline, paint thinner or other chemicals to clean the
unit.
3. Do not wash the unit directly under a tap or using a hose. It may
cause electrical damage.
4. If the power cord is damaged, contact the service depot immediately.
Clean the air fi lter at least once every two weeks. Accumulation of dust will hinder fan
operation.
REMOVAL
This unit has three fi lters. Lift the upper fi lter out in the direction of the arrow (Fig. 23),
then down. Remove the lower fi lter in the direction of the arrow in Fig. 23. Remove the
lower side fi lter in the direction of the arrow in Fig. 23.
CLEANING
1. Wash the air fi lter by submerging it gently in warm water (about 40°C / 104° F)
with a neutral detergent.
2. Rinse the fi lter and let it dry.
REINSTALL
Install the air fi lters after cleaning, as shown in Fig. 23. *Filters should dry before
installing*
Use a lint-free cloth soaked with neutral detergent to clean the unit enclosure,
be sure to wring the cloth of excess water. Finish by wiping with a clean dry
cloth.
•
Remove the rubber plug at the back of the unit and attach a hose to the drain
outlet. Place the open end of the hose directly over the drain area in your base-
ment fl
•
Remove the plug from the bottom drain outlet, this means that all the water in
the bottom drain tray will drain out.
•
Keep the appliance running on FAN mode for half a day in a warm room to dry
the appliance inside and prevent mold formation.
•
Turn off the appliance and unplug it, wrap the cord and bundle it with tape.
•
Remove the batteries from the remote control.
•
Clean the air fi lter and reinstall it.
Lower fi lter
IMPORTANT
oor.
Upper fi lter
Lower fi lter
14
Lower fi lter
Fig.23
Publicité
