Danby DPA100CB7WDB Guide D'utilisation Et D'entretien page 14

Installation Instructions
INSTALLATION IN A
DOUBLE-HUNG SASH
WINDOW
1. Measure the adhesive foam seal to fi t the windowsill. Then cut the foam seal to
the proper length and attach it to the windowsill. Fig. 9
2. Adjust the length of the window slider kit to fi t the width of the window.
Shorten the adjustable window kit to fi t the width of the window if less than 72 cm
(28.3 inches). Open the window sash and place the window slider kit on the win-
dowsill. Fig. 10
3. Cut the foam seal (adhesive type) to the proper length and attach it on the top of
the window. Shown in Fig. 11
4. Close the window sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the open gap between the
top window sash and outer window sash. Shown in Fig. 12.
The window kit may need to be cut down to size. DO NOT BLOCK THE EX-
HAUST HOLE.
10
Foam seal A
(adhesive type)
72 cm - 2.07 m
.
-
28.3 in. 81.5 in
Windowsill
Window Kit
Windowsill
Foam seal
Fig.9
Window Kit
Fig.10
Fig.11
Fig.12