Philips MiniVac FC6132 Mode D'emploi page 11

Cleaning the filter unit
1 Press the dust compartment release button (1) and remove the
dust compartment from the appliance (2) (Fig. 14).
2 Pull the filter unit out of the dust compartment (Fig. 15).
3 To detach the outer filter from the inner filter, turn the filter outer
filter anticlockwise (1) and pull it off the inner filter (2) (Fig. 19).
4 Clean the inner filter and the outer filter with a brush. If the filters
are very dirty, clean them with a normal vacuum cleaner (Fig. 20).
5 Put the outer filter back onto the inner filter (1) and turn the
outer filter clockwise to lock it (2) (Fig. 21).
6 Place the filter unit back into the dust compartment (Fig. 17).
7 To reattach the dust compartment, align the slot on the dust
compartment with the projection on the appliance. First attach the
bottom of the dust compartment. Then push the top of the dust
compartment towards the appliance until it locks into place
('click') (Fig. 18).
Storage
1 Wind the cord round the body of the appliance (Fig. 22).
2 Fix the cord with the cord clip.
Replacement
Clean Air HEPA filter
The appliance is equipped with the special Clean Air HEPA filter.
This filter removes small particles from the outlet air. This not only
includes normal house dust, but also harmful microscopic vermin such as
house dust mites and their excrements, which are well-known causes of
respiratory allergies.
1 Press the button to release the Clean Air HEPA filter cover (1) and
remove the cover (2) (Fig. 23).
ENGLISH
11