Loading the appliance
Loading vaccines
When the temperature in the freezer has
stabilized, i.e. the temperature should be
below -15 to -20°C and the compressor
stops and starts, vaccines can be loaded.
The vaccines should be placed in the mid
part.
Loading and freezing of
icepacks
The icepacks should be placed in the ice-
pack compartment and the suspended tray
(MF 214 and MF 314). Make sure you have
a good contact between the icepack and
the evaporater surface. Fig. 5
If thermostat is set to a warmer position,
remember to check the temperature in
the vaccine compartment
Defrosting and cleaning
For the appliance to operate well and to
save energy, it is important that it is cleaned
and defrosted regularly.
When opening the appliance, moisture en-
ters and settles on inner cold surfaces and
forms a layer of frost or ice.
The layer of ice makes the freezer less ef-
ficient and must be removed , "defrosted".
It is recommended that the appliance be
defrosted every third month.
Defrosting
● Before defrosting the vaccines must be
moved to another working freezer or cold
box with icepacks. Switch off the appli-
ance and pull out the plug.
● Open the lids and leave it open.
● Keep the lids open to allow the frost to
melt completely.
Cleaning
● Once the appliance is defrosted it must
be cleaned.
● Clean the inside of the appliance with
a mixture of lukewarm water and a mild
detergent.
Fig. 5
● Allow the cleaned parts to dry completely.
● Clean the outside of the appliance with
a mixture of lukewarm water and a mild
detergent or soap.
● Close the lid and follow the procedures in
" Cool down of the appliance" page 6
7
GB