Burda SMART IP20 Mode D'emploi page 3

NOTE Key-hole slots, hocks and similar means, without any further provision to prevent the heater from being
inadvertently lifted off the wall, are not considered to be adequate means for fixing the heater securely to
the wall.
Compliance is checked by inspection.
The appliance should be fitted and connected by a qualified electrician
P :
OWER CORD
• The power cord must not come into contact with hot appliance parts!
• Never pull the plug out of the socket at the cord! Never
move the appliance by pulling at the cord or use the cord for carrying purposes!
• Do not coil the cord around the appliance! Do not use the appliance with the cord coiled!
• Do not crush the cord or drag it over sharp edges or place it over heated hotplates or naked flames!
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard
I :
NSTALLATION
• The appliance should be fitted and connected by a qualified electrician.
• Prior to starting any electrical work, the voltage must be switched off to make sure that the wiring is dead!
Only switch on the appliance when installation is complete.
S
WITCHING ON FOR THE FIRST TIME
• After switching on the appliance for the first time and following extended periods on non-use, the appliance
may smell for a short time.
C :
LEANING
• First, disconnect the equipment from the power supply system!
• After the appliance has cooled down, the housing can be wiped dry.
• Do not touch the quartz rods with your fingers, since stains could build up from such a contact.
• The reflector should be cleaned regularly
• Do not use any abrasive or caustic cleaning agents!
• Never immerse the appliance in water! Danger to life!
A -S S :
FTER ALES ERVICE
• All repairs must be referred to authorised personnel! Therefore, you should contact your specialized dealer or
the customer service.
Important! Any tampering with the appliance will invalidate the warranty.
• Repairs carried out improperly and by unqualified persons may have serious consequences for the user!
T :
ECHNICAL DATA
SMART IP20
Rated voltage: 230-240 V/50 Hz
Rated output: 1500W/2000W
Dimensions (LxWxD) 40,5x14,5x9,5cm
Weight about: 2,5 kg
Protective system IP20
Appliances for wall mounting shall be constructed so that they can be secured to a wall
You can download this manual at our website, www.BurdaWTG.de
: