Amann Girrbach Ceramill motion 2 Instructions D'utilisation page 11

To remove the blank holder:
▷ With the door closed, press operation button [A]
for at least three seconds.
The current tool is placed down and the blank
holder [2] returns to the change position.
1
Fig. 5 Five-axis model
1
2
Fig. 6 Four-axis model
Legend to figure 5 and figure 6:
1 Fastening screw for blank holder
2 Blank holder
▷ Loosen fastening screw [1].
▷ Pull off the blank holder toward the right (five-
axis model) resp. toward the bottom (four-axis
model).
▷ Clean the locating bore and surfaces.
Blank holders not in use can be placed on
the storage rack and thus securely stored.
2
Fig. 7
A P P L I C A T I O N
E N
11