Publicité
Les langues disponibles
Les langues disponibles
EN
machine or clothes dryer, as the humidity may damage the hob electronics.
•
The installation will comply with all clearance requirements and applicable
standards and regulations.
When you have installed the hob, make sure that
•
The power supply cable is not accessible through cupboard doors or drawers.
•
If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
•
Disconnect the appliance from the mains electricity supply before carrying out any
work or maintenance on it.
Connecting the hob to the mains power supply (F9)
Wire colour code:
A) Black
B) Brown
C) Grey
D) Blue
E) Green/Yellow
Before connecting the hob to the mains power supply, check that:
1.
The domestic wiring system is suitable for the power drawn by the hob.
2.
The voltage corresponds to the value given in the rating plate.
3.
The power supply cable sections can withstand the load specified on the rating
plate.
4.
The installation is fitted with an efficient earthing connection in line with current
regulations and law. The earth connection is a legal requirement.
-
To connect the hob to the mains power supply, do not use adapters, reducers, or
branching devices, as they can cause overheating and fire.
-
Where the appliance is not supplied with a cable or plug, use suitable material for
the current indicated on the rating plate and for the operating temperature. The
cable must never reach a temperature of more than 50 °C above the ambient
temperature.
-
The power supply should be connected in compliance with the relevant standard,
or a single-pole circuit breaker.
•
The installer must ensure that the correct electrical connection has been made and
that it is compliant with safety regulations.
•
The cable must not be bent or compressed.
Publicité
