Publicité
Les langues disponibles
Les langues disponibles
EN
To start cooking
1.
Touch ON/OFF for 3 seconds (2). After power on, the buzzer beeps once, all displays
show "–", indicating that the induction hob has entered the state of standby mode.
2.
Place a suitable cookware on the cooking zone that you wish to use. Make sure
the bottom of the cookware and the surface of the cooking zone are clean and dry.
3.
According to the cooking zone where the cookware is placed, press the desired
zone selector (6).The symbol "0." selected will flash.
4.
Set a power level between 1 and 9 by sliding along the "slider" (3) key, or just
touch any point of the "slider" (3).
5.
If you don't choose a power setting within 20 seconds, the induction hob will
automatically switch off. You will need to start again at step 1.
•
You can modify the power setting at any time during cooking.
If the display flashes alternately with the power setting
This means that:
• The cookware is not placed on the correct cooking zone or,
• The cookware is not suitable for induction cooking or,
• The cookware is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable cookware on the cooking zone.
The display will automatically turn off after 1 minute if no suitable cookware is placed
on it.
When you have finished cooking
1.
Touch the power level slider (3) to decrease the power to "0" level.
2.
Press the "-" of power level slider (3) will decrease the power to "0" level or press
the "+" and "-" at the same time, the power level will decrease to 0 straight away.
3.
Beware of hot surfaces.
After switching off the cooking zone, the corresponding power display will indicate "H"
until the temperature in the zone has dropped below the critical level. It will disappear
when the surface has cooled down to a safe temperature.
Publicité
