Publicité
Les langues disponibles
Les langues disponibles
Description
1 Shaver foil
2 Cutter block
3 Foil release buttons
4 Long hair trimmer
5 Comfort setting switch «sensitive»
6 On/off switch
7 Shaver display
8 Replacement light for shaving parts
9 Reset button
10 Shaver power socket
11 Special cord set
12 Case
Charging
The best environmental temperature for
charging is between 41 °F to 95 °F / 5 °C to
35 °C. Do not expose the shaver to
temperatures higher than 122 °F / 50 °C for
extended periods of time.
•
Using the special cord set (11), connect the
shaver to an electrical outlet with the motor
switched off and charge it for at least one
hour.
•
A full charge provides up to 45 minutes of
cordless shaving time. This may vary
according to your beard growth.
•
If the rechargeable battery has run out of
power (discharged), you may also shave by
connecting the shaver to an electrical outlet
via the special cord set.
Shaver display
The shaver display (7) shows the charge
status of the battery.
Model 560: During charging or when using
the shaver, the respective green battery
segment will blink. When fully charged, all
green segments will light up continuously,
provided the shaver is switched on or
connected to an electrical outlet.
(Model 550: 1 green charging segment only.)
8
The red low charge segment flashes when
the battery is running low. You should be able
to finish your shave.
Shaving
Press the on/off switch (6) to operate the
shaver.
Comfort setting switch «sensitive»
Setting the shaver head according to your
comfort needs.
The «sensitive» switch (5) provides three
options for comfort setting:
1
« + » :
The shaver head is in full swing, freely
follows the contours of your skin to
provide more comfort.
2
Middle position:
The shaver head is semi-fixed for more
control.
3
« – » :
The shaver head is fixed for full control
and precise handling in hard to reach
areas.
Long hair trimmer
To trim sideburns, moustache or beard, slide
the long hair trimmer (4) upwards.
Tips for the perfect shave
For best shaving results, Braun
recommends you to follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against the
direction of your beard growth.
Cleaning
The hand-held unit should be detached from
the power supply cord before cleaning. The
shaver should not be used until it has dried.
Publicité
