Outside Living Industries ubbink 7524430 Notice De Montage page 9

WARRANTIES - After-sales service
Swimming pool 430 - H120 cm
Warranty conditions:
The swimming pool must be assembled within 48 hours of the package being opened.
For the warranty to be valid, a concrete slab must be in place.
Our warranty covers only the replacement of defective parts. It in no way covers demands for compensation or damages. The general warranty does not apply in the following circumstances:
• Use of the equipment in a way which is not in accordance with the instructions.
• Damage incurred as a result of bad handling during and after assembly. or any changes made to structural elements without the manufacturer's agreement
1) Pump : 2 year warranty (electrical problems) under normal conditions of use. The following are not covered by the warranty: damage due to abrasion or corrosion (particularly in the case of treating the water by
salt electrolysis), damage due to a faulty connection, equipment dismantled or repaired by a third party, breakage of parts (pump stand, pre-filter cover, grooved end fitting), using the pump when it is empty or
immersing the pump (e.g. if the pump house is flooded). The warranty is not valid if the electric cable and/or the plug are replaced, removed or damaged.
2) Liner : 2 year warranty under normal conditions of use. The following are not covered by the warranty: rips, holes, tears, stains (treatment products put straight into the water) stains related to the development
of algae, stains related to decomposing foreign bodies in contact with the liner, stains and discolorations resulting from the impact of oxidising products, discoloration and wear due to materials rubbing on various
surfaces. Distortions in the liner if it has been out of water for more than 24 hours (never completely empty your pool). See the warranty document that comes with the liner.
3) Filter : 2 year warranty under normal conditions of installation and use: tank, drain plug, collar and multiport valve.... The following are not covered by the warranty: problems with waterproof sealing due to
operating at a level of pressure which exceeds the maximum pressure permitted (see instructions for the filter).
4) Skimmer : 2 year warranty on the waterproof seals.
5) Wooden structure : 10 year warranty against rotting and damage caused by insects. The following are not covered by the warranty: changes in the colour of the wood caused by the climate, natural distortions
(splits, cracks, knots and minor flaws in the tongues of the planks which do not have any adverse effect on the mechanical strength of the wood or on the assembling of the pool). The warranty does not cover incor-
rect assembling or storage which may cause the wood for the sides of the pool to become warped (assembling the pool a long time after contents have been taken out of the packaging) or distortion of the planks
by the pressure of the water, which does not have any detrimental effect on the mechanical resistance of the pool. Any additional protection of the wood for the structure can only be undertaken using a product
which is compatible with autoclave treatment.
IMPORTANT : The after-sales service will be available only at point of sale.
Essential records for claiming the warranty:
- Till receipt / proof of purchase.
- Photograph of the damaged part or the problem in question
Shop :
City :
Contact department :
Direct tel :
Code Ref. Désignation
M 7514095 Plank 45 x 145 x 1780 mm
MS 7514036 Upper plank 45 x 135 x 1780 mm
2MS 7514039 Upper 1/2 plank 45 x 67 x 1780 mm
2MI 7514041 Lower 1/2 plank 45 x 77 x 1780 mm
MSS 7514045 Upper skimmer plank 45 x 135 x 1780 mm
MIS 7514069 Lower skimmer plank 45 x 145 x 1780 mm
MR 7514077 Water jet plank 45 x 145 x 1780 mm - 2008
PR 7514097 Post 45 x 135 x 1275 mm (reinforcement)
7514114 Sacrifice part 45 x 135 x 280 mm
PF 7514113 L-section finish 28 x 70 x 1260 mm
C 7514048 Console edging 45 x 230 x 170 mm
Wooden stop block for the skimmer flap
7514049
30 x 20 x170 mm
PL 7100201 Pair of rungs for wooden ladder H120/130 cm
T 7514052 Wooden ladder steps/Skimmer flap 28 x 145 x 600 mm
MSD 7514054 Pine outer right skimmer edging 28 x 145 x 526 mm
MSG 7514055 Pine outer left skimmer edging 28 x 145 x 526 mm
MGI 7100210 Pine edging 28 x 145 x 1529 mm Int.
MGE 7100215 Pine edging 28 x 145 x 1653 mm Ext.
7514149 Sandbag (25kg)
R 7514015 Hung 2.06 ml hanging rails
7514750 3-step stainless steel ladder
Poolmax TP
Filtration
Flexible pipe, 8 m
S Skimmer large
JM Anodised aluminium joint
Ground protection felt
Wall protection felt
NOTICE 430 - H120-2018/1.indd 9
- Warranty filled out correctly.
- Reference number of the faulty part.
Client :
Address :
City :
Tel :
Qty Qty
Hardware kit
7514755
parcel ASS
58
Code Ref. BREAKDOWN OF THE HARDWARE KIT
3
A3 7514638 Console + reinforcer bag
4
C3 7514616 Hung rails bag
4
DMI 7514553 Edging screw bag
1
DMP1 7514617 Edging screw bag
1
E 7514145 Skimmer flap bag
1
F 7514620 Aluminium edging joint bag
8
G 7514146 Wooden ladder + finishing profile bag
2
16
16
2
1
5
1
1
8
7
2
8
1
1
1
1
1
8
2
1
PR
8
II / 18-1
7512003 Beige 75/100 liner 430 - H120 cm
1
Qté Qté
parcel ASS
7514005 Blue 75/100 liner 430 - H120 cm
2
1
7514910 Grey 75/100 liner 430 - H120 cm
1
1
1
1
1
PL
T
1
or
1
or
1
21.12.17 07:46