Publicité
Les langues disponibles
Les langues disponibles
- -
[
SECTION 5 • PRODUCT SPECIFICATIONS
)
Troubleshooting
Measurement
Ranges
Problem
Possible Solution
Temperature
Relocate the main unit and/or the wireless
Main Unit: 32°F to 122°F / 0°C to 50°C
sensor. Both units must be within 100 feet [30
Wireless Sensor: -40°F to 158°F / -40°C to 70°C
Bad
ml from each other. Make sure both units are
placed at least 3 feet [.91 ml from other
Wireless Sensor
Humidity
electronic appliances and devices that may
Reception
interfere with the wireless communication
Wireless Sensor: 1% to 99% Relative Humidity
Main Unit: 16% to 98% Relative Humidity
[such as TVs, microwaves, computers etc].
NOTE:
It may take up to 20 minutes for the
main unit to re-synchronize with the sensor
no bars
Wind Speed
Too□~
when batteries are replaced.
Use lithium
Wireless Sensor: 0 to 100 m.p.h. / 0 to 161 kph
batteries in sensor when temperature is
below -4°F (-20°C).
Specifications
Rotate the wireless sensor 90° on its mount-
Power Requirements
Atomic Clock
ing point. Make certain there are no large
Main Unit: 3 x "M' alkaline or lithium batteries
Frequency: WWVB 60Khz
stone or metallic surfaces disrupting the
Wireless Sensor: 4 x "M" alkaline or lithium batteries
Synchronizes Daily
signal line-of-sight to the state of Colorado.
Bad
Make sure the main unit and wireless sensor
Atomic Clock
Wireless Communication 433 MHz Radio Frequency-Transmission every 18 seconds
are placed at least 3 feet [.91 ml from other
Reception
electronic appliances and devices that may
interfere with the wireless communication
[such as TVs, microwaves, computers etc].
Set Wireless ID
no bars
Large metallic surfaces will interfere with the
This wireless thermometer
Too□~
atomic clock signal.
uses long range 433mhz
radio frequency for
communication.
If wireless reception is bad [no bars]. see
No Wireless Sensor Data
..
Bad Reception
..
section above. The wireless
[no communication]
In the event that you have
ID setting on each unit must match for all
'I;
reception problems due to
-r
no bars and flashing
units to communicate properly. See
..
Set
interference, both the main
antenna icon
Wireless ID" on the previous page.
unit and the wireless sensor
; I'
have a selectable wireless
Make certain that the batteries are installed
ID. The ID switches are
Main Unit
correctly and that they are contacting the
located within the battery
terminals. Make certain all contacts are clean.
Display Not Working
compartments of the main
The batteries may need replacing.
unit and the wireless
sensor.
You may choose A, B or C;
but both the main unit and
Please DO NOT return
product
to the retail
store.
For technical assistance and product return information, please call
the wireless sensor ID's must
match for successful
Customer Care:
877-221-1252
Mon. - Fri. 8:00 A.M. to 4:45 P.M. [CST]
synchronization.
Both wireless ID's
www.chaneyinstrument.com
must match
-
12 -
-
13
-
Publicité
