ACU-RITE 00634 Manuel D'instructions page 3

Install Batteries
NOTE: Install all batteries in both units within a 6 minute period to ensure proper
wireless functionality.
Always install batteries into the wireless sensor FIRST.
Wireless Sensor - 4 "AA" Batteries Required
[not included)
0
GENTLY SQUEEZE OUTER
0
REMOVE BATTERY
CASING AND PULL INNER
COMPARTMENT COVER
INSTRUMENT POD OUT
PULL
INSERT 4 FRESH "il'
8
SET THE OUTER CASING
~
BATTERIES AND REPLACE
ASIDE, TAKE CARE THAT IT
~
BATTERY COMPARTMENT
IS NOT DROPPED
COVER.
~
REPLACE BATTERY
0
RE-INSTALL INNER
~
COMPARTMENTCOVER
INSTRUMENT POD UNTIL
TABS ALIGN AND YOU
YOU HEAR A "CLICK"
INSERT
- 4 -
Install Batteries
NOTE: Install all batteries in both units within a 6 minute period to ensure proper
wireless functionality.
Always install batteries into the wireless sensor FIRST.
Main Unit - 3 "AA" Batteries Required
[notincludedl
0
REMOVE BATTERY
0
REPLACE BATTERY
COMPARTMENT COVER
COMPARTMENT COVER
~ INSERT 3 FRESH "il'
"'BATTERIES
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY
SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY:
Clean the battery contacts and also those of the device prior to battery
installation. Remove batteries from equipment which is not to be used for an extended
period of time. Follow the polarity(+/-] diagram in the battery compartment. Promptly
remove dead batteries from the device. Dispose of used batteries properly. Only batteries of
the same or equivalent type as recommended are to be used. DO NOT incinerate used
batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix
old and new batteries or types of batteries (alkaline/standard]. DO NOT use rechargeable
batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply
terminals.
- 5 -