Publicité
Les langues disponibles
Les langues disponibles
-
-
[SECTION
4 • PLACEMENT
)
--'o' ✓
...
I'
I \'
MOUNT INAN
OPEN AREA FOR
I
~
:1
I
3
feet
I
UN-OBSTRUCTED
WIND SPEED
1.91
ml
MEASUREMENT
100 feet maximum
[30 meters]
Now that setup is complete and you understand how to operate the weather
station, you must choose a location to place the wireless sensor and the main
unit. The wireless sensor MUST be placed less than 100 feet (30 meters] away
from the main unit.
This wireless weather station uses radio frequency for communication, which is
susceptible to interference from other electronic devices and large metallic
items or thick walls. Always place both units at least 3 feet (.91 ml away from
appliances
I
TV, microwave, radios, etc.
1
or objects that may interfere with the
wireless communication
I
large metal surfaces, thick stone walls, etc. ).
Please USE EXTREME CARE when handling the wireless sensor and the main
unit. The wireless sensor contains sensitive electronic components and a
balanced anemometer (for wind speed measurement). Care must be taken
during setup and when considering placement to make certain the unit is not
dropped or struck with any falling debris from trees or structures.
USE CAUTION when utilizing tools or equipment for mounting the wireless
sensor. Enlist the help of another individual when necessary.
Placement of Main Unit
Place the main unit in a dry area free of dirt and dust. To help ensure
an accurate indoor temperature measurement, be sure to place the
main unit out of direct sunlight, and away from any heat sources or
vents in your home. For the best atomic clock signal reception, place
the main unit with the back side facing the state of Colorado.
There are 2 placement options for the main unit. You may hang the
main unit on a wall using the integrated hang hole. Alternatively, you
may place the main unit on a table top or other flat surface using the
included detachable table top display stand.
- 10 -
Placement of Sensor
The wireless sensor MUST BE MOUNTED OUTDOORS to observe outdoor
temperature/humidity/wind
speed and relay the information to the main
unit display. The wireless sensor must be placed less than 100 feet (30 ml
from the main unit.
The wireless sensor
must be mounted securely. It is advised that the
wireless sensor be mounted well above and away from all obstructions
to report the wind speed accurately. There are three main mounting options
to consider:
"FENCEPOST" O R SIMILAR MOUNTING
"RAILING" OR SIMILAR MOUNTING
TIGHTEN
CLAMP
SCREWS!
"'POLE"
OR SIMILAR MOUNTING
Mount the sensor onto a
3/4"
schedule
40
(25.8
mm O.D.l pipe (not included). PVC plastic pipe is
recommended over a metallic pipe due to lower
risk of lightening strikes.
Insert the pole completely into the bottom of the
wireless sensor. Tighten the "CLAMP" screws
securely to make certain the wireless sensor
INCLUDED
will not fall or slide off of the pole in high winds.
MOUNTING
BRACKET
NOT USED
Use caution when installing sensor or erecting
the pole. Do not install during electrical storms.
Do not place pole or sensor near electrical
(POLE NOT
INCLUDED)
transmission lines or electrical equipment.
- 11 -
Publicité
