Süd wind ambientika Manuel De Configuration Et D'utilisation page 28

INTRODUCTION – TECHNICAL DATA
The heat recovery system is categorized as a class II product with IPX4 protection degree. The
heat recovery system is projected for indoor installations with working temperatures between -
30°C and +50°.
The design of the heat recovery system is in continuous evolution; therefore, some models may
differ from those described in this manual.
DIMENSIONS (mm)
TECHNICAL PARAMETERS
Voltage at 50Hz [V]
Max efficiency
Speed
Flow rate [m3/h]
Power [W]
Noise at 3m dB(A)
INSTALLATION – INTRODUCTION
Installation must only be carried out by properly qualified person.
Make sure that the main electrical supply in the installation room is disconnected before starting
the electrical operations of assembly.
The appliance must not be installed near curtains, drapes, etc. as these could compromise the
correct working of the product.
Make sure that, once installed, the center of the hole (160mm) has a distance of 30 centimeters
from the ceiling. In case of installation of more than one appliance, the distance between the
products must be at least 3 meters.
200
Night
20 40
3,9 4,9
6,5 14
28
220-240
93%
1 2
70
7,4
22
3
100
11,9
32