Horizon Global 118855 Instructions D'installation page 5

Always wear SAFETY GLASSES
when installing wiring harness
8. In the passenger's side taillight located in the bumper. Locate the
connector matching the end of the T-One® Connector. Insert the T-
One® Connector end containing the green wire in between the vehicle
and taillight connectors. All connector's surfaces should be clean and
free of dirt.
©2023 Horizon Global Corp
Installation Instructions
PART NUMBER: 118855
9. From inside of cargo area on the driver's side of vehicle behind
Note:
10. Locate a suitable grounding point near the black box such as an
Verify what is behind any surface prior to drilling to avoid damage to
the vehicle and/or personal injury. Do not drill into any exposed
surfaces.
partially removed trim panel close to the grommet, determine a
suitable mounting point behind the rear bumper fascia on the
driver's side. Mount the T-One® Connector black box using the
double-sided tape provided.
Clean flat mount surface area using a 50-50 mixture of rubbing
alcohol and water to mount lighting module black box.
existing ground stud or drill a 3/32" hole and secure the white
wire using the eyelet and screw provided. (Do not drill into vehicle
floor or bed.) Clean dirt and rustproofing from area.
Sheet 5 of 24 118855-NP 2/20/2024 Rev. A