Publicité
Les langues disponibles
Les langues disponibles
Always wear SAFETY GLASSES
when installing wiring harness
1. Open the rear hatch. On the driver's side , using a trim panel tool, Phillips screwdriver, or 10mm socket remove the plastic threshold cover, cargo
trays, and the side panel exposing the vehicle's taillight wiring harness. Be careful not to break mounting tabs.
2. Locate the taillight wiring connector on the driver's side. Disconnect
the vehicle wiring harness. Locate the connectors matching the end of
the T-One® Connector. Insert the T-One® Connector end containing the
brown and red wires in between the vehicle and taillight connector. All
connector's surfaces should be clean and free of dirt
©2023 Horizon Global Corp
Installation Instructions
PART NUMBER: 118855
3. Locate the grommet underneath the exposed area. Route the T-One®
.
Connector ends containing the yellow and green wires through the
grommet. Carefully slit the grommet so that both wires and the T-One®
Connector ends go thru it to the other side of vehicle's body.
If routing the wire thru a grommet and along the exterior
of the vehicle, be careful to avoid any hot pipes, heat shields, the fuel
tank or any other points that may pinch or break the wire.
Sheet 3 of 24
118855-NP
2/20/2024
Rev. A
Publicité
