Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Open the door to a 90° angle and remove two
screws from the door axis. Slide the bottom of
the door outward to remove it from the chassis.
See fi gures A and B.
2. Remove three screws from the top right hinge
and remove the right top hinge. See fi gure C.
3. Remove the screw hole covers from the top left
of the cabinet and install the top left hinge at the
top left of the cabinet with three screws. Block
the holes at the top right of the cabinet with the
screw hole covers. See fi gure D.
4. The lower left hinge is preinstalled on the
cabinet. See fi gure E.
5. Install the door by sliding it onto the top hinge
pin, then replace the door axis by placing the
hinge pin in the bottom of the door and securing
it to the bottom left hinge with two screws.
Ensure the top of the door is properly aligned
with the top of the cabinet and that the rubber
gasket makes a good seal with the cabinet all
the way around. See fi gures F and G.
1. Bottom Right Hinge
2. Door Axis Screws
3. Door Axis
4. Top Right Hinge
5. Hinge Screws
6. Top Left Hinge
7. Screw Hole Cover
8. Bottom Left Hinge
A
B
C
D
6
E
8
F
G
7
1
2
3
4
7
6
3
2
8
5
Publicité
