Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
significantly, which means that all its components will become very hot as the device has
been operating at high pressure. Both light indicators, 1 and 2, will start blinking quickly,
indicating the device's temperature must be decreased.
-
To cool the device down:
-
Rotate the steam knob to the water position, the machine will start dispensing water for
a few seconds.
-
When the indicator lights start flashing slowly, turn the steam knob to the 0 position.
-
When the power light indicators remain steady on, the device is ready to use again.
Please note
The coffee machine features an auto-off safety system that activates after 25 minutes the
machine is not being used.
4. CLEANING AND MAINTENANCE
-
Disconnect the device from the power supply and allow it to cool down completely before
cleaning.
-
Do not use abrasive cleaners or scouring pads as they could cause damage to the product's
surface.
-
Use a soft, dampened cloth to clean the outer part of the device.
-
Do not immerse the main body in water or other liquids.
-
Wash the water tank, drip tray and cup holder tray regularly.
-
After using the steam function, the tube must be cleaned with a cloth immediately after.
Be careful not to burn yourself! Allow steam to be released to avoid possible blockages
inside the tube.
-
If the steam tube is clogged, use a needle to unblock the conduct.
-
Remove the coffee machine arm after each use and empty the coffee residues inside. Then,
use water and a cloth to clean it. Do not wash it in the dishwasher.
-
Clean all parts with water and dry thoroughly before storing it or using the device again.
-
Cleaning mineral deposits or descaling
-
Mineral deposits built up in the unit might affect the machine's operating. It is important
to remove and clean them to keep the coffee machine operating efficiently. The quality of
the water being used and type of use will determine how often these deposits must be
cleaned.
-
It is recommended to carry out a cleaning cycle after each 1000 uses.
Fill the water tank to the MAX mark and add a descaling agent. Place the arm in its place.
Place one container under the arm coffee machine arm and another under the spray nozzle
and activate the coffee and hot water functions alternately until the tank is completely empty.
38
CAFELIZZIA STEEL
Warning
-
Use the water and descaling agent proportions indicated on the product's packaging.
-
Repeat this process just with water to remove any rests.
5. TROUBLESHOOTING
Problem
Cause
Coffee does not come out
No water in tank.
Coffee grind is too fine.
There is too much coffee in
the filter.
The device is not turned on
or connected to the power
supply.
Coffee has been tamped/
compressed too much.
No water/steam.
There is no water in the
water tank or it is not
installed properly.
The machine is not
preheated.
The vaporiser's tube is
clogged.
Coffee comes out around
Portafilter not rotated to
the edge of the portafilter.
full lock position.
There is ground coffee on
the edge of the filter.
There is too much coffee in
the filter.
Coffee is too light.
Coffee is not enough
ground or the grounds are
not pressed enough.
ENGLISH
Solution
Add water.
Grind medium-ground coffee.
Fill filter with less coffee.
Connect the unit to a power
supply and turn it on.
Refill the filter basket with coffee,
do not tamp too much.
Fill the tank with water and turn
on the device.
The machine needs to be hot
before emitting water/steam.
Once the machine is preheated,
the light indicator will turn on.
Clean the vaporiser's tube with a
needle or fine wire.
Rotate filter holder to full lock
position.
Wipe off the rim.
Fill with less coffee.
Use a finer grind or use the dosing
spoon/presser to press it well.
CAFELIZZIA STEEL
39
Publicité
