dB Technologies IA 504D Manuel D'utilisation page 48

English
CONTROLS
STANDBY
Connecting a switch to put the amplifier in standby.
Contact closed => standby mode. It is configured in the
GPIO => Configure section of the AURORA NET software.
GPI - BUTTON/SWITCH CONNECTION
Connecting a button/switch powered by the IA504D amplifier (on the left) or powered externally (on the right). It
is configured in the GPIO => Configure section of the AURORA NET software.
GPO - LED CONNECTION
Connecting a LED powered by the IA504D amplifier (on the left) or powered externally (on the right). It is
configured in the GPIO => Configure section of the AURORA NET software.
IA540D
Cod. 420120399 REV. 1.0
48