Publicité
Les langues disponibles
Les langues disponibles
9
E E T T H H 1 1
11
9. ANALOGUE AUDIO INPUTS
Analogue audio inputs on 3.81mm Euroblock connectors. Using AURORA NET software it's possible to set IN1 as
AES/EBU digital stereo input, this commutes IN2 as AES/EBU digital stereo output.
10. CONTROLS
Connections in 3.81mm Euroblock format, which can be used as GPI, GPO, analogue and as a dedicated standby
input. For further details, read the GPIO chapter in this manual.
11. DANTE® PORTS
Two standard Ethernet RJ45 ports in switch configuration. The control is with PC with AURORA NET software
installed, while the digital audio streaming is with Dante® protocol.
!
CAUTION
•
Please use only CAT5 shielded cable for Ethernet ports connection
12. POWER OUTPUTS
Power output on a 5.08mm Euroblock connector. It can be used with an impedance of 4, 8 or 16 Ohm in single-
channel mode, or 8 or 16 Ohm in bridge mode, and can drive 100V or 70V systems. dBTechnologies has created
presets for its own passive speakers, which can be downloaded via the AURORA NET software for an optimal
listening experience.
POWER SUPPLY SECTION
13. POWER SOCKET
For use with the power cable provided. The power supply is of the full range type.
!
CAUTION
•
Do not obstruct the amplifier cooling fins at the back. In the event of overheating, the
audio volume is gradually reduced until the module is thermally stable. The level is
automatically restored on reaching the correct operating temperature.
•
In the event of malfunction, immediately turn off the power and disconnect the module
from the mains. Contact an authorised service centre.
•
Do not attempt to open the amplifier.
•
Periodically check the connection cables to ensure they are in good condition.
IA540D
34
10
E E T T H H 2 2
12
English
13
Cod. 420120399 REV. 1.0
Publicité
