Zanussi TCE 7245 Mode D'emploi page 5

Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the laundry
at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of
the water by using the following procedure.
To access adjustment mode:
Turn the programme selector dial to switch on the
appliance. In selection mode, press simultaneously
the buttons 2 and 4.
IPress the buttons down until the pilot lights above
each ones begin to flash and one of the pilot lights
indicating the drying phase lights
or end cycle remains lit
9h
6h
3h
1 2 3 4 5
Adjusting the level of conductivity:
Press the button sequentially: the level of
conductivity is indicated by the lighting of the
horizontal hyphens.
, cooling ,
0
Conductivity
Display
Medium
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Memorizing the new setting:
Simultaneously press the buttons 2 and 4.
Press the buttons down until the pilot lights above
each ones stop flashing and the buzzer sounds.
5
Approximative
degree value (µS/cm)
Low < 300
300 - 600
High > 600