Publicité
Les langues disponibles
Les langues disponibles
Environmental Monitoring and Weather Functions:
• Humidity measurable range: 20%RH ~ 95%RH.
• Measurement accuracy for humidity: ±5%, Resolution: 1%
• Indoor temperature measurement ranges: -9.9°C (14.2°F) ~ 50°C (122°F).
• Outdoor temperature measurement ranges: -40°C (-40°F) ~ 70°C
(158°F).
• Temperature accuracy: ±1°C from 0°C (32°F) to 40°C (104°F), otherwise
±2°C, Resolution: 0.1°C.
• Temperature can be displayed in either °C or °F.
• Maximum/minimum value records of temperature and humidity.
• Wireless Outdoor Sensor with 3 selectable channels and 50-meter trans-
mission range.
• Barometric pressure measurement ranges: 850 ~ 1100 mB/hPa
(25.10 ~ 32.48 inHg).
• Pressure can be displayed in mB/hPa or inHg.
• Weather forecasting and air pressure detection.
• Ice alert for temperatures between -1.0°C to 2.9°C (30.2°F to 37.3°F).
• Outdoor temperature alert function.
• Comfort indicator for indoor and outdoor conditions.
• Weather symbols display for weather forecasting.
Power Supply:
• Battery: 2 x LR03 AAA (not included) - Adapter: DC5V 600mA.
• Remote sensor: 2x LR03AAA (not included)
16
4 | Initial Operation
• Open the main unit's battery compartment cover.
• Insert 2 x AAA batteries, observing the polarity («+» and «-»).
• Upon battery insertion, all icons on the LCD will light up for 3 seconds, ac-
companied by a beep tone, and the indoor temperature and humidity will
be detected.
• The main unit will then establish a connection to the outdoor remote sensor,
indicated by a flashing reception antenna symbol in the upper right corner,
showing the number of channels.
• Simultaneously, open the remote sensor's battery compartment cover,
select the desired channel using the channel switch, insert 2 batteries
with the correct polarity, choose the temperature unit (°C or °F) using the
«°C/°F» button, and close the battery cover.
• Once the main unit successfully connects to the outdoor remote sensor
within 3 minutes, it will enter the DCF Radio control time receive mode
(backlight turns off during RC reception). The backlight will remain on after
successful DCF reception.
5 | Reception of the Radio Signal
Press and hold the «[
]» button to enter the DCF radio control receiving
function. When using the adapter, the backlight will temporarily turn off
during receiving mode and return to the previous brightness after receiving.
In DCF receiving mode, the «[
detected, the flashing stops, and the symbol switches to «[
minutes, the receiving process will end, indicated by:
«[
]» Received successfully if the reception was successful.
«[
]» The previous reception was successful, but the last reception failed if
the last attempt failed.
Ref. 3044 - Installation and user manual
]» symbol will flash. Once a valid signal is
]». After a few
EN
17
Publicité
