Publicité
Les langues disponibles
Les langues disponibles
8820193 'Nano Carbon' Variable Shade Auto-Darkening Welding Helmet V1.1
SENSITIVITY
The sensitivity control (#4) is set according to the welding
process and ambient light.
1.
Low Setting - suitable for high amperage welding and
welding in areas with high levels of natural sunlight.
2.
Medium Setting - suitable for most indoor and outdoor
welding.
3.
High Setting - suitable for low amperage welding and
welding in areas with low light conditions, especially for
low amperage argon-arc welding.
GRINDING MODE
You can also use the welding helmet to protect your face
during grinding. Select grind mode by pushing the shade
control (Fig. 1-1) lever to the bottom. This will prevent the filter
cartridge from darkening when bright sparks are created.
TEST BUTTON
Press the test button on the auto-darkening filter (Fig. 1-3). The
red battery indicator light will glow and the filter will darken to
indicate the electronics are functioning.
Replace the battery if the battery indicator light is dim. Replace
the filter if the battery indicator light is bright, but the filter
does not darken.
MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace
damaged or worn components.
3.
When servicing, use only identical replacement parts. Only
use accessories intended for use with this tool. Replace
damaged parts immediately.
8
For technical questions call 1-800-665-8685
Publicité
