Publicité
Les langues disponibles
Les langues disponibles
8820193 'Nano Carbon' Variable Shade Auto-Darkening Welding Helmet V1.1
PARTS IDENTIFICATION
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect
for damage. Make sure that all items in the contents are included.
Contents: • Welding Helmet Shell • Internal and External Lenses
• Cartridge Filter
ASSEMBLY
The welding helmet is preassembled. Remove the protective film
from both lenses before use.
ADJUST THE WELDING HELMET FIT
The headband should be adjusted both in diameter and height.
The angle between face and helmet should also be adjusted
(recommended 10° to 12°).
1.
Adjust the headband diameter with the headband adjusting
knob (#12) on the headband. Twist clockwise to tighten and
counterclockwise to loosen.
2.
Adjust the headband height by changing the top strap
hole (#9).
3.
Adjust the helmet position on the headband. Loosen the
headband knobs (#17), adjust the helmet forward or
backward and then tighten the knobs. Make sure the helmet
is adjusted the same on both sides for proper vision.
4.
Adjust the helmet to get the desired viewing angle. Once the
angle is correct, tighten the two angle adjustment shims (#14)
connecting the headband to the helmet shell until snug. The
helmet should still swing up, but it should not drift downward
when in place for welding.
6
• Headgear • Battery
For technical questions call 1-800-665-8685
Publicité
