Sony ICF-SW100S Mode D'emploi page 31

For Better SW/MW/LW Reception
Using the Active Antenna AN-100 (supplied for
ICF-SW100S)
When using the active antenna, collapse the telescopic antenna.
1 Set SENS of the radio to DX.
2 Pull out the output cable from the active antenna and
plug it into the ACTIVE ANT jack.
3 Extend the telescopic antenna of the active antenna.
4 Set AM BPF FREQ to WIDE. When the sound is distorted, set it to
a suitable frequency range.
5 Turn on the radio and tune in the desired station.
It is also possible to set the antenna module on the floor.
Note After use
Connect only the antenna recommended 1 Collapse the telescopic antenna.
in this manual to the ACTIVE ANT jack. 2 Reel up the output cable.
Do not connect any other type, since :
power (DC 3V) is supplied to this jack
for the specific antennas.